Common Failures of CHERY J693630030 ABS sensor for TIGGO3X/TIGGO2/Celer Sedan Facelift
- Sensor Malfunction: The ABS sensor (OE: J693630030) in TIGGO3X, TIGGO2 and Celer Sedan Facelift may malfunction, causing the ABS warning light to illuminate.
- Inaccurate Signal Transmission: Sometimes, this ABS sensor fails to transmit accurate signals, affecting the normal operation of the anti - lock braking system in these models.
Maintenance Tips of CHERY J693630030 ABS sensor for TIGGO3X/TIGGO2/Celer Sedan Facelift
- First, locate the ABS sensor on your CHERY TIGGO3X, TIGGO2 or Celer Sedan Facelift. It's usually near the wheel hub. Check the OE number J693630030 to ensure you have the right part.
- Before installation, clean the sensor mounting area thoroughly. Any dirt or debris can affect the performance of the ABS sensor.
- Connect the electrical connector carefully. Make sure it's securely attached to avoid loose connections that could cause ABS malfunctions.
- When installing the sensor, align it properly with the tone ring. Incorrect alignment can lead to inaccurate readings.
- After installation, test the ABS system. Drive the vehicle at a low speed and perform a few gentle stops to check if the ABS is functioning correctly.
Electrical Shock Warning – The ABS sensor has electrical components. Disconnect the battery before installation to prevent electrical shock.