Common Failures of CHERY 554000104AB Door Seal for TIGGO8 PRO PHEV/TIGGO8 PRO/TIGGO8/TIGGO7/TIGGO7 PRO
- Seal Degradation: In many TIGGO models like TIGGO8 PRO PHEV, the door seal (OE: 554000104AB) often degrades over time, leading to leaks.
- Poor Sealing Performance: A common issue, especially in TIGGO7 and TIGGO7 PRO, where the door seal fails to provide a tight seal, causing wind noise.
Maintenance Tips of CHERY 554000104AB Door Seal for TIGGO8 PRO PHEV/TIGGO8 PRO/TIGGO8/TIGGO7/TIGGO7 PRO
- Firstly, before installing the CHERY Door Seal (OE# 554000104AB) on TIGGO8 PRO PHEV, TIGGO8 PRO, TIGGO8, TIGGO7 or TIGGO7 PRO, clean the door frame thoroughly to ensure good adhesion.
- Secondly, measure the length of the old door seal accurately. This helps in cutting the new CHERY Door Seal to the right size, preventing gaps.
- Next, start installing the seal from one corner of the door. Make sure it fits snugly into the groove, avoiding any twists.
- Then, check the seal's alignment along the entire door edge. A misaligned seal can lead to poor sealing and wind noise.
- Finally, after installation, close the door a few times to test the seal. If there are any loose parts, re - adjust the CHERY Door Seal.
Caution: Do not over - stretch the CHERY Door Seal (OE# 554000104AB) during installation as it may cause permanent damage and reduce its sealing effectiveness.