Common Failures of CHERY A136207030BA Door glass pressure strip for TIGGO3X/TIGGO2/Celer Sedan/Celer Hatchback/Celer Sedan Facelift/Celer Hatchback Facelift
- Loose Fitting: In many TIGGO3X and Celer models with OE number A136207030BA, the door glass pressure strip may fit loosely, causing rattling noises.
- Sealing Issues: A significant number of TIGGO2 and Celer Facelift vehicles face problems where the A136207030BA door glass pressure strip fails to seal properly, leading to water leakage.
Maintenance Tips of CHERY A136207030BA Door glass pressure strip for TIGGO3X/TIGGO2/Celer Sedan/Celer Hatchback/Celer Sedan Facelift/Celer Hatchback Facelift
- First, before installing the CHERY door glass pressure strip (OE# A136207030BA), clean the door frame thoroughly. Remove any dirt or debris to ensure a proper fit.
- Next, check the pressure strip for any visible damage. If there are cuts or tears, it's best to replace it immediately.
- When installing the strip on TIGGO3X, TIGGO2, Celer Sedan, or other models, start from one end of the door frame and carefully press it in place. Make sure it follows the contour of the frame.
- It's important to ensure the strip is evenly seated. Use a plastic tool to gently press it down further if needed.
- Finally, test the door glass operation. Roll the glass up and down to ensure the strip doesn't interfere with its movement.
Caution: Do not over - stretch the CHERY door glass pressure strip during installation. Over - stretching can cause it to lose its elasticity and lead to improper sealing.